Poly-Fine® II Series Filter Cartridges

Food Contact Compliance

Please refer to the Pall website for a Declaration of Compliance to specific National Legislation and/or Regional Regulatory requirements for food contact use.

Technical Information

The technical information provided is based on controlled laboratory tests done on typical production filters at the conditions described, unless otherwise indicated. Actual operating conditions may affect the filter's performance.

Operating Characteristics¹

¹Fluids which do not swell, soften or adversely affect any of the filter components
²Recommended change-out differential pressure is 2.4 bard (35 psid), provided the maximum differential pressure (based on temperature) is not exceeded.

Typical Flow Rates³

³Typical initial clean delta p per 254 mm (10 inch) cartridge, water at 20° C (68° F). For liquids with viscosity greater than 1cP, multiply the delta p by the viscosity.

Sterilization and Sanitization

Multiple autoclaving for 30 minutes at 1 bar (15 psig) steam (121 °C /250 °F) under no end load conditions, up to 10 cycles. In-line steam sterilization is not recommended. May be in-line sanitized with hot water at 82 °C (180 °F) for 1 hour.

Ordering Information

This information is a guide to the part numbering structure and possible options. For availability of specific options please contact Pall. Refer to Pall for housing details.

Part Number: PFT [Table 1] [Table 2] U [Table 3] [Table 4] W 480

Example Part Number:PFT02530USM7W480

See bold reference code in tables.

Table 1:Removal Rating⁴

⁴Poly-Fine II filter cartridge liquid retention ratings are determined by a single pass test based on ASTM F-795 (see Pall Technical Bulletin 1903-4T). Removal efficiencies are shown at the stated rating in compatible fluids.

Table 2: Nominal Length

⁵Please contact Pall for specific dimensions of SI option cartridges.

Table 3: O-Ring / Gasket Seal Material

⁶for M3, M7, M8 options only

Table 4: Adaptor